MIMAKI (THAILAND) CO., LTD.

Edge part on print result has slurred on Bi-directional printing

  • Please check the following contents.

Print result has slurred to right and left such as above photo "No good",
please check followings.

1. If you change type of media or head height, perform [DROP.POS correct].

2. Check head height. Recommended head height is 2mm or less.

3. if winkles (cockling) appears on media surface, check followings.

 - Increase temperature of pre heater by approximately 20℃ than
  temperature of print heater and check whether cockling is increased.

 - When you use roll media, feed the media approximately 1 meter from
  tens of centimeters. Cockling may disappear as the media djusts.

 - Do not leave the media being heated with the heaters for a long time.
  Otherwise media will be cockled.

4. Reset the media once again.
  If media is slanting, skew problem will be occurred and cause of
  poor image quality.

If you still having the same issue, please contact us.


Return to Content

PAGETOP